Careers Directions
Phone: 1.888.428. 3415
Decorative Iron Fences
Architectural
Maverick Industrial Solid
Maverick Privacy Panels
Maverica Industrial Iron
Maverick Commercial Iron
Maverick Residential Iron
Ornamental Swing Gates
Ornamental Slide Gates
Therma-Fused Polyolefin &  Framework
Custom Work
Accessories
Aluminum Deck Railing
Build Sheets & Specifications
Request A Quote
Installation Directions
FAQs
Testimonials
Going Green
 
Manufacturers of Aluminum Deck Railings

Our aluminum deck railing designs are great for a variety of applications including residential, commercial and condominiums. This decorative product is maintenance-free, resists fading, highly durable and available in several
different colors. No more painting your deck rails, worrying about rust or
splintering wood. This product meets or exceeds IBC 2006, BOCA, FHA building codes and ICC 2006 building codes. Engineering shop drawings available upon request.

Available in a wide variety of colors, unlike vinyl railing. Minimal maintenance
required. Our aluminum railing meets and/or exceeds IBC 2006, BOCA, FHA and ICC 2006 building codes. Our aluminum railings come from welded construction and have a powder coat finish. Engineered shop drawings are available.

 
  • 1013.2 Height: Guards form a protective barrier no less than 42 inches high for multifamily and ng units in occupancies in Group R-2 guards are 36 inches high. Other heights are available upon request.
  • 1607 Load: Handrail assembles and guards are designed to resist a load of 50 lpf (0.73kN/m) applied in any direction at the top and transfer loads throughout the support of the structure. One to two family dwellings require a single concentrated load. Handrails assembles and guards can resist a single concentrated load of 200lbs (0.89kN) when applied in any direction at any point.
  • Openings: Open guards have balasters or ornamental patterns such that a 4 inch diameter (102mm) sphere cannot pass through any opening up to a height of 34 inches (864mm). A sphere of 8 inches (203mm) in diameter will not pass through on heights 34–42 inches above the adjacent walking surfaces. One exception includes a triangular opening formed by the riser, tread and bottom rail at the open side of a stairway that has a maximum size
    to ensure that a sphere of 6 inches in diameters does not pass through the opening.
  • Masonry anchors 2 at 3/16 dia. x 2 deep for collars cap and bottom for walls that are structurally sound (brick tied) or use blocking similar to facia/siding attachment.
 
 
     
Download a full-length PDF of the Iron World Aluminum Deck Railing brochure >>
 
The environmentally safe powder coating finishing process provides a long lasing minimum maintenance finish. After a 5 stage metal preparation process, power is
electrostatically applied for uniform coverage. The powder is melted and allowed to flow uniformly over the surface covering all exposed areas and then cured hard at 425°. No thinners or other VOC (Volatile Organic Compounds) are released into the environment. No micro fine holes in film to allow corrosion. Typical thickness of coating is 5 times the thickness of a painted product.
 
Typical Corner or End Post